7-52
Setup Mode
The Setup Editor
Riff
Setting the Riff parameter to On will enable the riff feature for the current zone in setup mode.
Setting this parameter to Off will disable the riff for this zone.
Song
Select the song you wish to use in the Song parameter by using the Alpha Wheel, -/+ buttons, or
the alphanumeric pad.
Start
Use the Start parameter to specify the riff start point. The time format is Bar : Beat : Tick. Bar can
be set to any bar in the sequence, and Beat can be set to any beat in that bar (beat range is
dependent on time signature.) Tick can be set from 0 to 959. Since there are 960 possible start
points within a beat, you can specify your riff to start on any common beat subdivision
moments (and a few uncommon ones). The following Tick values correspond to the following
beat subdivision moments:
Stop
Use the Stop parameter to specify the riff stop point. Like the Start parameter, the time format
for Stop is Bar : Beat : Tick. Bar can be set to any bar in the sequence, and Beat can be set to any
Beat Subdivision
Beat Subdivision
Moment
Tick Value
Quarter note 1st 0
8th note
1st 0
2nd 480
8th note triplet
1st 0
2nd 320
3rd 640
16th note
1st 0
2nd 240
3rd 480
4th 720
16th note quintuplet
1st 0
2nd 192
3rd 384
4th 576
5th 768
16th note triplet (sextuplets)
1st 0
2nd 160
3rd 320
4th 480
5th 640
6th 800
Table 7-2
Subdivision
Values
To Next Page
Loading...
