13-38
Tutorials: Setup Mode
Creating A New Setup
Creating A New Setup
Follow these steps if you would like to create a new setup from a blank template.
1. If you are not already in Setup mode, press the Exit button until you reach the ProgramMode page,
then press the Setup mode button, located with the mode buttons to the left of the display. This will
bring you to the Setup mode main page (see below.)
2. Use the - / + buttons or Alpha Wheel to select the setup 128 Default Setup or use the
alphanumeric pad to enter 128 and press Enter (see below.)
3. With the setup 128 Default Setup selected, press the Edit button on the front panel. This will
bring you to the CH/PROG page of the setup editor (see below.)
4. On the CH/PROG page, select the Program field (see above.) Select a program for Zone 1 using
the Category buttons, - / + buttons, the Alpha Wheel or the alphanumeric pad.
To Next Page
Loading...
