13-8
Tutorials: Setup Mode
Using Setup Mode To Play Layers Of Instruments
Using Setup Mode To Play Layers Of Instruments
In a setup you can set Zone key ranges that overlap. This creates layers of instrument programs
that are played from the same key range. As an example, let’s use the setup 38 Jazz Bass/Piano, a
split setup of bass and piano, and add a layer of strings to the piano section:
1. Press the Exit button until you reach the ProgramMode page. Next, press the Setup mode button,
located with the mode buttons to the left of the display. This will bring you to the Setup mode main
page.
2. Use the - / + buttons or Alpha Wheel to select the setup 38 Jazz Bass/Piano or use the
alphanumeric pad to enter 38 and press Enter (see below.)
3. With the setup 38 Jazz Bass/Piano selected, press the Edit button on the front panel. This will
bring you to the CH/PROG page of the setup editor (see below.)
4. On the CH/PROG page use the Chan/Zone buttons to the left of the display to select Zone 2.
You can view the number of the selected Zone in the top right corner of screen. In the Program
field you can view the instrument Program for the current Zone. We can see that the program for
Zone 2 of this setup is the piano program 8 Grand “Evans” (see below.)
To Next Page
Loading...
