13-18
Tutorials: Setup Mode
Assigning A Single Knob To Control Relative Volume In Different Zones
4. On the Controllers page, use the Chan/Zone buttons to the left of the display to select Zone 2.
You can view the number of the selected Zone in the top right corner of screen.
5. On the Controllers page for Zone 2, the Controller field will be highlighted (if not, select the
Controller field with the cursor buttons.) Make sure the LED to the left of the Timbre Knob is lit, if
it is not, press the Shift button to the left of the Knobs until that LED is lit. Next, hold the Enter
button on the alphanumeric pad and move the Knob labeled Timbre. This will select Knob 1 for
the Controller field (see below.) You can also set the desired controller in the Controller field by
using the Alpha Wheel or - / + buttons.
6. With Knob 1 selected in the Controller field, use the cursor buttons to select the DestType field and
then use the Alpha Wheel or - / + buttons to select Ctrl (see below.)
To Next Page
Loading...
