Introducing the PC88
Unpacking the Unit…
1-2
PC
88
Unpacking the Unit…
is pretty straightforward. ItÕs always a good idea to keep the box and packing material, in case
you need to ship it for any reason. Your PC88 carton should contain the following:
•
PC88 Performance Controller
•
AC adapter
•
switch pedal
•
six adhesive-backed rubber feet
•
manual
•
warranty card
Setup
Set the PC88 on a keyboard stand or table. Always make sure the ends are supported Ñ not just
the middle. Use the stick-on rubber feet if youÕre putting the unit on a ßat surface (or even if
you might in the future). As shown in the following illustration, pairs of guide holes on the
bottom of the PC88 show recommended locations for the feet. Remove the backing paper from
each rubber foot, then attach to the bottom of the PC88, just forward of a pair of guide holes.
Plug the audio outputs into your mixer or ampliÞer, and set your system up to listen in stereo.
If you have another MIDI instrument, run a cable from the PC88Õs
MIDI Out
jack to the MIDI
In of that synth. Connect the supplied switch pedal to the jack labelled
Switch Pedals 1
.
Locate the small plug at the end of the wire on the power supply. Locate the
9.5V~AC In
socket
on the rear panel. Next to the socket is a protruding plastic strain relief ÒTÓ. Wrap the wire once,
not too tightly, around the strain relief, and insert the plug into the socket, as shown below.
Now plug the large end of the power supply into an AC socket. Turn on the power by pushing in
the side of the switch with the white dot. The two-line LCD display in the middle of the instrument
comes to life and welcomes you to the PC88. Turn up the audio, and weÕre ready to go.
Thru Out
MIDI Select
MIDI In9.5V AC InPower
.0A
Use Kurzweil Power pply 95-20 y
To Next Page
Loading...
