Kurzweil SP6-7 - Page 34

Program Mode
SPLIT/LAYER
2-10
Split Mixer Page / Layer Mixer Page
Volume
e Volume parameter sets the volume of each Zone. To change the volume of a Zone:
1. Select a Volume parameter for the desired Zone by using the PREVIOUS and NEXT
buttons.
2. Change the volume by using the ALPHA WHEEL, or use the keypad function of the
CATEGORY buttons to type a volume value (0-127) followed by pressing the ENTER
button.
A value of “None” can also be selected, which will use the last volume value used by the
Zone’s MIDI channel. (is volume values is often set by the expression pedal.) A value of
“None” can be entered by using the ALPHA WHEEL to scroll below 0.
Pan
e Pan parameter sets the panning (left/right stereo placement) of each Zone. To change the
panning of a Zone:
1. Select a Pan parameter for the desired Zone by using the PREVIOUS and NEXT
buttons.
2. Change the panning by using the ALPHA WHEEL, or use the keypad function of the
CATEGORY buttons to type a pan value (0-127) followed by pressing the ENTER
button.
A value of 0 is full left, 64 is center, and 127 is full right. Other values will move the stereo
placement in between these positions.
A value of “None” can also be selected, which will use the last pan value used by the Zone’s
MIDI channel. A value of “None” can be entered by using the ALPHA WHEEL to scroll
below 0.