Kurzweil SP6-7 - Panic

Multi Mode
PANIC
4-12
To name a Multi:
1. Use the PREVIOUS and NEXT buttons to move the cursor to each character.
2. Change the current character by using the ALPHA WHEEL, or use the keypad function
of the CATEGORY buttons to type a character.
To insert a space before the selected character, press and hold the NEXT button. e selected
character and all characters to the right will move one space to the right.
To delete the selected character, press and hold the PREVIOUS button. All the characters to
the right of the selected character will move one space to the left.
After naming the Multi, press the SAVE button to return to the Multi Save Page. On the
Multi Save Page, press the SAVE button again to save the Multi as a User Multi.
Saving a User Multi
To save a User Multi, select the Multi Save Page and press the SAVE button, (or press the
EXIT button to exit without saving). e display will show a brief message to conrm that
the Multi was saved.
After successfully saving, the Multi will be selected in Multi Mode in the User ID range
(1025-2048). To nd the Multi again later, make sure to press the USER button.
PANIC
Pressing the 0 and ENTER buttons simultaneously performs the PANIC function. PANIC
deactivates all sounding notes and resets controller values by sending an “All Notes O ”
message and a “Reset All Controllers” message on all 16 MIDI channels.