Kurzweil SP6-7 - Common Page

Multi Edit Mode
Common Page
5-11
e Destination parameters work in combination with the LOCAL DEST button on the
front panel. e Destination parameters and the LOCAL DEST button each act like lters.
For example, if the Zone 1 Destination parameter is set to LOCAL, and the LOCAL DEST
button is set to LOCAL + MIDI, MIDI data from Zone 1 will be sent to LOCAL only.
Common Page
Tempo
Use the Tempo parameter to set the rate of the Arpeggiator or tempo synced FX (such as
Delay). You can set a value by using the ALPHA WHEEL, or by using the keypad function
of the CATEGORY buttons to type a value followed by pressing the ENTER button.
e value of the Tempo parameter can also be set by tapping the TAP TEMPO button at the
desired rate.
Clock Src
Use the Clock Src (Clock Source) parameter to set whether the selected Multi will use its
own tempo, or whether it will sync with the tempo from an external MIDI device.
Set the Clock Src parameter to Internal to use the tempo set by the Tempo parameter.
Set the Clock Src parameter to External to use the tempo from an external MIDI device.
When the Clock Src parameter is set to External, an external MIDI device must be sending
MIDI clock data to the USB or MIDI in port.
Revrb Chan
Use the Revrb Chan (Reverb Channel) parameter to set the MIDI channel which will be
used for Reverb. e Reverb eect of the Program loaded in the selected MIDI channel will
be used for all Programs in the current Multi. To view the MIDI Channel of each Zone, see
Channel Page on page 5-10.