4
Gather all of the following tools and materials.
You will need these tools to complete the
installation.
•Adhesive tape
• Eye protection
•Pencil
•Scriber
• Light hammer
• Center punch
• 3.75" (95 mm) hole saw
• Electric drill
• 5/8" (16 mm) drill bit
• File
•75RG-6 and/or RG-11 RF coax cables
and F-connector installation tools (see
“Cable Requirements” on page 10)
• Snap-N-Seal
®
F-connectors (or
equivalent)
• Silicone sealant (or equivalent)
•Heat shrink gun
• Wire strippers
• Wire crimpers
• #1 Phillips screwdriver
• 5/32" hex key
• 7/16" open-end torque wrench set to
20 in-lbs (2.25 N-m) of torque
• 7/16" socket/ratchet or nut driver
• 1/2" open-end wrench
• 3/4" socket/ratchet or wrench
• 3/4" socket/torque ratchet capable of
settings between 35 and 40 ft-lbs (47 and 54
N-m) of torque
• Voltmeter
• Isolation transformer, if required (see “AC
Power Requirements” on page 11)
• PC (preferably with Internet access)
•X-ACTO
®
knife
• Needle-nose cutting pliers
• Ruler or tape measure
• NMEA interface cable (for heading input)
Gather Tools
2
To Next Page
Loading...
Need help?
General
