KVH Industries TracVision G6 User Manual

TracVision G6
Installation & Technical Manual
This manual provides detailed instructions on the proper
installation, configuration, troubleshooting, and maintenance of
the KVH TracVision G6 system. Complete instructions on how to
use the TracVision G6 system is provided in the TracVision G6
User’s Guide.
Throughout this manual, important information is marked for
your attention by these icons:
Direct questions, comments, or suggestions to:
KVH Industries, Inc. KVH Europe A/S
50 Enterprise Center Ved Klaedebo 12
Middletown, RI 02842 USA 2970 Hoersholm Denmark
Tel: +1 401 847-3327 Tel: +45 45 16 01 80
Fax: +1 401 849-0045 Fax: +45 45 86 70 77
E-mail: info@kvh.com E-mail: info@kvh.dk
Internet: www.kvh.com Internet: www.kvh.com
If you have any comments regarding this manual, please e-mail
them to manuals@kvh.com. Your input is greatly appreciated!
A helpful tip that either directs you to
a related area within the manual or
offers suggestions on getting the
best performance from your system.
An alert to important information
regarding procedures, product
specifications, or product use.
An electrical safety warning to help
identify electrical issues that can be a
hazard to either this KVH product or
a user.
Information about installation,
maintenance, troubleshooting, or
other mechanical issues.
KVH Part # 54-0161 Rev. D (Unreleased)
© 2003, KVH Industries, Inc.
TracVision G6 Serial Number
This serial number will be required
for all troubleshooting or service
calls made regarding this product.
Welcome to TracVision G6

KVH Industries TracVision G6 Specifications

General

Elevation Range	0° to 90°
Antenna Diameter	18 in (45.7 cm)
Power Consumption	30 W
Operating Temperature	-25°C to +70°C
Tracking	Automatic
Compatible Satellites	DIRECTV and DISH Network satellites
Azimuth Range	360°
Power	12V DC
Wind Survival	Up to 100 km/h
Simultaneous Feeds	Single

Summary

Installation

Planning the Installation

Mounting the TracVision Antenna

Provides step-by-step instructions for mounting the TracVision antenna unit.

Mounting the GyroTrac Sensor

Wiring the ADCU

Provides detailed instructions for wiring the ADCU and its various connections.

Calibrating the Sensor

Explains how to calibrate the GyroTrac sensor for accurate heading data.

Installing Satellites Using the ADCU

Details the process of selecting and installing satellite pairs via the ADCU interface.

Using the ADCU Interface

Startup and Self-test

Describes the system startup sequence and self-test procedures, including error detection.

Control Compass Mode

Antenna Status Mode

Control Antenna Mode

Enables manual antenna adjustment, restart, sleep mode, and satellite configuration.

Troubleshooting

Troubleshooting Matrix

Identifies trouble symptoms, their possible causes, and references for solutions.

Causes and Remedies for Common Operational Issues

GyroTrac-specific Issues

Maintenance

PCB Removal and Replacement

Antenna Gyro Assembly

Antenna LNB Replacement