KVH, TracVision, and the unique light-colored dome with contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2008 KVH Industries, Inc., All rights reserved. 54-0439 Rev. B
1
These instructions explain how to replace the main PCB (printed circuit board) in a
TracVision R5SL/R4SL system.
Installation Steps
Tools Required
This procedure requires the following tools:
Technical Support
If you need technical assistance, please contact KVH Technical Support:
1. Replace the Main PCB...2
2. Check for Flash Wizard Updates...4
3. Flash Both Antenna Boards...4
4. Configure the Antenna...4
5. Install Satellites...5
6. Enter your GPS Position (Optional)...7
• 11/32" open-end wrench
• Needle-nose pliers
•Phillips-head screwdriver
• Needle-nose pliers
•PC with the latest version of the KVH Flash
Update Wizard installed
NOTE: The Flash Update Wizard is available to KVH-
authorized dealers through the KVH Partner Portal.
Phone: +1 401 847-3327
E-mail: techs@kvh.com
The main PCB is static-sensitive. Ensure that you take the necessary grounding precautions
before handling.
IMPORTANT!
Main PCB Replacement Instructions for
TracVision
®
R5SL/R4SL
To Next Page
Need help?
General
