Need help?Do you have a question about the KVH Industries TracPhone V3-HTS and is the answer not in the manual?
General| Frequency Band | Ku-band |
|---|---|
| Stabilization | 3-axis stabilized |
| Wind Survival | Up to 100 knots |
| Operational Wind Speed | Up to 50 knots |
| Operating Temperature | -25°C to +55°C |
| Humidity | 95% non-condensing |
| Type | Maritime VSAT Antenna |
| Tracking | Automatic satellite tracking |
| Compatibility | Compatible with all major service providers |
Select an optimal position for the antenna, considering vessel centerline, temperature, and potential interference.
Ensure the mounting surface is flat, level, and strong enough to support the antenna and withstand operational forces.
Specifies minimum requirements for pedestal height, tube diameter, and brace dimensions if a pedestal is used.
Instructions for securing the ICM unit within a standard 19-inch equipment rack.
Steps for mounting the ICM unit directly onto a horizontal surface.
Guidelines for preparing and terminating the 75Ω RF coax cables, including cable types and connectors.
Instructions for routing the prepared RF and power/data cables from the antenna location to the ICM.
Connects the ICM to itself using an Ethernet jumper cable for communication.
Connects the two supplied Wi-Fi antennas to the rear panel of the ICM unit.
Details wiring the power and data cable from the antenna to the ICM's terminal strip.
Connects a vessel heading input device to the ICM for system operation.
Connects the RF coax cables from the antenna to the ICM's transmit and receive jacks.
Outlines the necessary AC power specifications, including voltage and wiring configurations.
Emphasizes the critical importance of proper system grounding for safety and equipment protection.
Guides users on how to verify the installed ICM/Antenna software version via the web interface.
Provides steps to upload and install newer software versions using the web interface.
Instructions to change the default administrator login password for system security.
Details how to set a custom name for the vessel, displayed on the home page and in communications.
Steps to assign names to phone lines, such as 'Bridge' or 'Not Used,' for clarity.
Guides through starting the commissioning process, entering location, and satellite parameters.
Details setting modulation, adjusting transmit power, and entering P1dB values for final calibration.
Sets up unrestricted high-speed Internet access via Ethernet ports and Wi-Fi.
Configures static IP addresses for devices, reserving port 4 for optional KVH services.
Implements user logins, passwords, and data allocations for restricted network access.
Enables and configures the ICM's built-in Wi-Fi access point for vessel network connectivity.
Details connecting an analog phone or PABX to the ICM's designated voice line port.
Instructs the installer to provide the customer with the Welcome Kit and explain system operation and safety.
Directs users to the web interface's Support page for additional help and documentation.
To Next Page
