HORN / LIGHTS INSPECTION
• Turn the ignition switch to the “ON” position and push the horn
button to check if it sounds
• Headlight / Taillight inspection:
Start the engine and turn on the headlight switch to check if the
headlight and taillight are working properly. Also check the
light shells for any dirt and damage.
• Brake light inspection:
Apply the front and rear brake levers respectively to check if the
stoplight is working properly. Also check the light shell for
dirt and damage.
• Turn Signal Light inspection:
Operate the turn signal switch to ensure that the right/left front
and rear turn signal lights flash. Also check the light shells for
dirt and damange
(1) Headlight
(2) Taillight / Stoplight
(3) Turn Signal Light
(4) Horn
Replace any dirt or damaged lights with new
ones to avoid danger and ensure a safe ride!
- 29 -
To Next Page
Loading...
