model comes with a battery that DOES NOT
require refilling of distilled water.
als, remove the screws attaching the
pen the battery cover.
rroded, take the battery out
battery terminals and then install the battery.
• Never open the closed-type battery electrolyte cap.
• The battery discharges electricity when the scooter
is not used for a long period of time. Remove the
battery and put it in a cool place after it is fully
time
Do not smoke or allow flames or sparks near the battery
while removing and installing it.
• Turn “OFF” the ignition switch before removal or
installation.
• The negative ( - ) terminal should be removed first and the
positive ( + ) terminal should be installed first.
• Tighten the loose terminal nuts securely.
- 47 -
• This scooter
• When cleaning the termin
battery cover on the floorboard and then o
als are co
• If the battery termin
and clean it.
• After cleaning, apply a thin coat of grease or Vaseline to the
charged to prevent electricity leakage.
riod of
• If the scooter will not be used for a long pe
e negative ( - ) terminal.
remove th
•
To Next Page
Loading...
