(1) Engine stop switch " "
""
(2) Headlight switch (for
genuine KYMCO
accessories)
(3) Start switch " "
(1)
(2)
(3)
Engine stop switch
When the switch is in the RUN ( ) position, the
engine will operate. When the switch is in OFF
( ) position, the engine will not operate.
This switch is intended primarily as a safety or
emergency control, and it should normally
remain in the RUN ( ) position.
If you stop your ATV by turning the engine stop
switch OFF ( ), be sure to turn the ignition
switch OFF to prevent battery discharge.
NOTE:
21
Handlebar switches
To Next Page
Loading...
