During this period, prolonged full throttle
operation or any condition which might result in
excessive engine heating must be avoided.
However, momentary (2~3 seconds maximum)
full throttle operation under load does not harm
the engine.
Each full throttle acceleration sequence should
be followed with a substantial rest period for the
engine by cruising at lower r/min so the engine
can rid itself of the temporary build up of heat.
If any abnormality is noticed during this period,
consult a KYMCO dealer.
1. 0~10 hours:
Avoid continuous operation above half
throttle. Allow a cooling off period of five to ten
minutes after every hour of operation. Vary
the speed of the machine from time to time.
Do not operate it at full throttle position.
2. 10~20 hours:
Avoid prolonged operation above 3/4 throttle.
Rev the machine freely through the gears but
do not use full throttle at any time.
3. After break-in
Avoid prolonged full throttle operation. Vary
speeds occasionally.
46
(1)Locked position
Parking
When parking, stop the engine. Turn the fuel
lock to "OFF" and apply the parking brake.
Make sure the lock pin into the locked position.
To set the parking brake, see page 28.
(1)