GENERAL INFORMATION
ATV IDENTIFICATION
NUMBERS
Two keys come with the ATV. Keep the
spare key in a safe place. An identify-
ing number is stamped on each key.
Use this number when ordering a
These numbers are required by the
dealer to complete warranty claims
properly. No warranty will be allowed
by KYMCO if the VIN or ESN is
removed or mutilated in any way.
Always provide the ATV name, Vehi-
cle Identification Number, and Engine
Serial Number when contacting an
authorized KYMCO ATV dealer for
parts, service, accessories, or warranty.
If a complete engine must be replaced,
ask the dealer to notify KYMCO for cor-
IGNITION SWITCH KEY
removed in this position.
Ignition Switch
CONTROL LOCATIONS
The ignition switch has three positions.
55
The KYMCO ATV has two identifica-
tion umbers: Vehicle Identification
Number (VIN) and Engine Serial
The VIN is located on the lower-front
Number (ESN).
crossmember.
VIN
The ESN is located on the rear of the
engine crankcase and is visible from
the side.
rect registration information.
replacement key.
K
MC
Y OK
MC
Y O
AND FUNCTIONS
OFF position - All electrical circuits
except the accessory plug are off. The
engine will not start. The key can be
removed in this position.
ON position - The ignition circuit is
complete and the engine can run. The
key cannot be removed in this position.
LIGHTS position - The ignition cir-
cuit is complete and the headlights and
taillight are on. The key cannot be
NOTE: The accessory plug is
powered by the battery at all times.
KC0055A
GENERAL INFORMATION
ATV-0056
ATV-0055
To Next Page
Loading...
