Do not attempt sudden stops or
put yourself into a situation where
a sudden stop will be required until
the brake pads are properly bur-
nished.
After the completion of the break-in
period, the engine oil and oil filter
should be changed. Other maintenance
after break-in should include checking
of all prescribed adjustments and tight-
ening of all fasteners. At the discretion
and expense of the owner/operator, the
ATV may be taken to an authorized
KYMCO ATV dealer for this initial
service.
65
CAUTION
BRAKE PADS MUST BE BUR-
NISHED TO ACHIEVE FULL BRAK-
Braking distance will be extended
until brake pads are properly bur-
TO PROPERLY BURNISH THE
BRAKES, USE FOLLOWING PRO-
ING EFFECTIVENESS.
nished.
CEDURE:
Choose an area sufficiently
large to safely accelerate ATV to
30 mph and to brake to a stop.
Accelerate to 30 mph; then com-
press brake lever to decelerate
to 0-5 mph.
‧ Repeat procedure 5 times.
‧
‧
WARNING
When the engine starts, allow it to
warm up properly. Idle the engine sev-
eral minutes until the engine has
reached normal operating temperature.
Do not idle the engine for excessively
During the first 10 hours of operation,
always use less than throttle. Varying
the engine RPM during the break-in
period allows the components to “load”
(aiding the engine/transmission com-
p o n ent m a t i ng p r oces s ) a n d t h e n
“ unload” (allowing components to
cool). Although it is essential to place
some stress on the engine components
during break-in, care should be taken
not to overload the engine too often.
Do not pull a trailer during the break-in
long periods of time.
period.
GENERAL INFORMATION
To Next Page
Loading...
