Kyocera Mita FS-1010 - Page 65

Other Settings
1-54
Broadcast
To send PRESCRIBE commands to the printer in network (TCP/IP)
connection, enter the command in the Broadcast text box. The maximum
length for a command sequence is 256 characters. Then click the SEND
button to send the command to the printer.
FRPO
FRPO is a PRESCRIBE command that permanently changes the printer’s
internal parameters. Each parameter is represented by two letters, such as
R4 for default paper source, succeeded by FRPO, then followed by a value.
For example, FRPO R4, 1; means that the default paper source (R4) is the
printer’s cassette (1).
To confirm the current value for an FRPO parameter:
To confirm the current value for an FRPO parameter:To confirm the current value for an FRPO parameter:
To confirm the current value for an FRPO parameter:
1
Enter the parameter (for example R4) in FRPO.
2
Click on GET. The current value is shown in Value.
To change the value for an FRPO parameter:
To change the value for an FRPO parameter:To change the value for an FRPO parameter:
To change the value for an FRPO parameter:
1
Follow the above procedure to display the current value in Value.
2
Erase the current value and enter the new value. For example, to
change the default paper source to the MP Tray in the above
example, enter 0 instead of 1 in Value.
3
Click SET. The value is changed.