An up-to-date compatibility list is available in the service area of www.kyoceramita.eu
Note
For some of the older supported devices, in certain cases it might be
necessary to make a firmware update.
Note
Please note that KM series multifunction devices have to be fitted with a
printer board.
Note
PCL Barcode Flash assumes that you have a free CF card slot in your printer
or multifunction device
Note
The following minimum requirements for the device used should be met so
that PCL Barcode Flash can run without complications:
• Firmware as of April 2001 or newer
• Min. 16 MB RAM recommended
8
To Next Page
Loading...
