Kyocera ECOSYS FS-C8525MFP Technical Reference Manual

Chapter 6
Permanent Parameters
The printing system maintains a number of parameters in a non-volatile (flash) memory.
These parameters control the initial state of the environment at power-up, including the
initial emulation mode, page orientation, character set, buffer allocations in memory,
interface parameters, and other options.
The parameters may be changed permanently with the FRPO (Firmware RePrOgram)
command. Some FRPO parameters affect only the current interface (interface-depen-
dent) and some affect all interfaces at once (non-interface-dependent). If the printing sys-
tem is shared with other users, remember that any changes to any non-interface-
dependent parameters may interfere with the print jobs of the other users. This chapter
explains the FRPO command and gives examples of its use.
The current settings of the FRPO parameters are listed as option values on the printing
system’s service status page. Refer to the tables in this chapter to interpret the values. To
print a service status page, command:
!R! STAT 1; EXIT;
Before changing any FRPO parameter, print out a service status page, so you will know
the parameter values before the changes are made. To return FRPO parameters to their
factory default values, send the FRPO INIT (FRPO-INITialize) command.

Kyocera ECOSYS FS-C8525MFP Specifications

General

Category	Printer
Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Duplex Printing	Yes
Standard Paper Capacity	500 sheets
Supported Paper Sizes	A4, A5, A6, B5, Letter, Legal
Memory	1 GB
Memory (Maximum)	2 GB
Connectivity	USB 2.0, Ethernet
Print Speed	25 ppm
Print Resolution	600 x 600 dpi
Copy Speed	25 copies per minute
Fax Resolution	400 x 400 dpi
Max Paper Capacity	1, 600 sheets
Operating Systems Supported	Windows, Mac, Linux
Type	Multifunction