Settings Pages
Set the SMTP Port Number, or use the SMTP default port 25. Choose the
default port number 465 for SMTP connections over SSL.
SMTP Server Name
Enter the SMTP server host name or its IP address. If entering the host
name, rather than the IP address, a DNS server address must also be
configured. The DNS server address may be entered on the TCP/IP General
page (refer to Advanced > Protocols > TCP/IP > General on page 6-32).
SMTP Server Timeout
Sets the timeout in seconds during which this device tries to connect to the
SMTP server.
Authentication Protocol
Enables or disables the SMTP authentication protocol or sets POP before
SMTP as the authentication type.
Authenticate as
Specifies the user to be authenticated in SMTP authentication. When POP3
User 1 to 3 (Refer to Advanced > E-mail > POP3 > User # on page 6-41) and
i-FAX User are set, you can select one of them. If you want to select a
different user, select Other and enter the login account name and login
password for authentication.
Login User Name
When Other is selected for Authenticate as, the account name set here will
be used for SMTP authentication.
Login Password
When Other is selected for Authenticate as, the password set here will be
used for authentication.
SMTP Security
Enables or disables the SMTP Security. When this protocol is enabled,
either SSL/TLS or STARTTLS must be selected. To enable SMTP security,
the SMTP port may have to be changed according to the server settings.
Typically, 465 for SSL/TLS and 25 or 587 for STARTTLS are well-known
SMTP ports.
POP before SMTP Timeout
Enter the timeout in seconds during which this machine tries to connect to
the SMTP server when set POP before SMTP as the Authentication
Protocol.
Test
Tests to confirm that the settings on this page are correct. When the Test
button is pressed, this machine tries to connect to the SMTP server.
E-mail Size Limit
Enter the maximum size of E-mail that can be sent in Kilobytes. When the
value is 0, the limitation for E-mail size is disabled.
Sender Address
Enter the E-mail address of the person responsible for the printing system,
such as the printer administrator. A reply or non-delivery report will go to a
person rather than to the machine. The sender address must be entered
correctly for SMTP authentication. Note that no mail message can be sent
unless the sender's address is specified.
Signature
COMMAND CENTER RX 6-39
To Next Page
Loading...
Need help?
General