Kyocera ECOSYS M6026cidn

2PX/2PY
1-4-40
(7)
No primary original
feed.
Check if the surfaces of the following pul-
leys are dirty with paper powder.
DP forwarding pulley
DP feed pulley
Clean with isopropyl alcohol.
Check if the following pulleys is
deformed.
DP forwarding pulley
DP feed pulley
Check visually and replace any
deformed (see page 1-5-82).
(8)
Multiple sheets of orig-
inal are fed.
Original is not correctly set. Set the original correctly.
Check if the DP separation pad is worn. Replace the DP separation pad if it is
worn (see page 1-5-86).
(9)
Originals jam.
Originals outside the specifications are
used.
Use only originals conforming to the
specifications.
Check if the surfaces of the following pul-
leys are dirty with paper powder.
DP forwarding pulley
DP feed pulley
Clean with isopropyl alcohol.
Check if the contact between the convey-
ing roller and conveying pulley is correct.
Check visually and remedy if necessary.
Check if the contact between the eject
roller and eject pulley is correct.
Check visually and remedy if necessary.
Check if the contact between the switch-
back roller and switchback pulley is cor-
rect.
Check visually and remedy if necessary.
Problem Causes/check procedures Corrective measures