2PX/2PY
1-2-14
1-2-4 Installing the SD card (option)
<Procedure>
1. Turn off the main power switch.
Caution: Do not insert or remove SD
card while machine power is on.
Doing so may cause damage to the
machine and the SD card.
2. Remove the IF cover.
(see page 1-5-3)
3. Remove two screws and then remove
the option interface slot cover.
4. Install the SD card into the option inter-
face slot.
5. Refit the option interface slot cover by
two screws.
6. Refit the IF cover.
Figure 1-2-23
Pin
Pin
SD card slot
SD card
Option interface
slot cover
To Next Page
Loading...
