Kyocera ECOSYS MA4500ix - Page 398

8-49
Setup and Registration (System Menu) > System Menu
eSCL over TLS Protocol
Settings
Selects whether to receive scanned documents using eSCL over TLS.
*1*2
Value: Off, On
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
VNC (RFB) Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use the Remote
Operation.
*1
The default port number is 9062.
Value: Off, On, 1 to 32767 (Port Number)
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
VNC (RFB) over
TLS
Protocol
Settings
This is set when starting up a VNC Viewer (E.g. RealVNC) to use Remote Operation
protected by TLS.
*1*2
The default port number is 9063.
Value: Off, On, 1 to 32767 (Port Number)
NOTE
When selecting [On], it also requires a certificate for TLS. The default certificate is
the self-certificate of the machine.
Command Center RX User Guide
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
Enhanced VNC
over TLS
Protocol
Settings
This is set when starting up Command Center RX to use Remote Operation
protected by TLS.
*1*2
The default port number is 9061.
Value: Off, On, 1 to 32767 (Port Number)
NOTE
• The default setting is [On].
• When selecting [On], it also requires a certificate for TLS. The default certificate
is the self-certificate of the machine.
Command Center RX User Guide
Available
Network
Set whether to enable this function for each network of Wi-Fi Direct, Wi-Fi and
wired.
Value: Disable, Enable
*1 The setting will be changed after restarting the device or network.
*2 Set "TLS" to [On] in Security Settings.
TLS (page 8-61)
IMPORTANT
Depending on the protocol, there are models where you need to restart the network or turn the
machine OFF and then ON after changing the setting.
Item Description