2-8
Connecting and Printing
Manual Feed (FS-1060DN/FS-1061DN only)
[GO] can be pressed on the printer operation panel to feed and print on one sheet of paper. This is convenient when
loading one envelope at a time in the Manual Feed tray.
1 Ensure Manual feed is selected as the Source in the Print
Properties dialog box.
2 Use Number of copies to enter the number of copies required.
3 Select OK to return to the Print dialog box and select OK.
4 Load the paper in the Manual Feed tray for the printer and press
[GO]. One sheet is printed.
5 Repeat step 4 until all pages are printed.
Manual Duplex (FS-1040/FS-1041 only)
To print on both sides of the paper using a FS-1040/FS-1041, use Manual Duplex. The even pages are printed first and
then reloaded to print the odd pages. An instruction sheet is available to assist with loading the sheets in the correct
orientation and order.
1 Select Print on both sides (manual duplex).
Select Flip on long edge if the binding will be on the long edge, or
Flip on short edge if the binding will be on the short edge. Select
Print manual duplex instructions to receive the instruction sheet.
2 Select OK to return to the Print dialog box and select OK to start
printing. A Manual Duplex Instruction message box displays. The
even pages are printed including the instruction sheet.
Note If Auto source selection has been selected, paper is
automatically fed from the Manual Feed tray. If there is no
paper in the Manual Feed tray, paper is automatically fed from
the cassette.
Note Ensure Print manual duplex instructions is selected to receive the instruction sheet. Continue to use the
sheet until you are familiar with this feature.
Note Instructions for manual duplex will be printed on the
instruction sheet.
To Next Page
Loading...
