Kyocera FS-1750 - Positioning the Printer; Clearance; Places to Avoid

1. Positioning the Printer
1
1. Positioning the Printer
Clearance
Allow at least the necessary minimum clearance around the printer (see below). A total
space of 92 cm by 61 cm by 138 cm (36-1/4 by 24-1/16 by 54-5/16 inches) is needed.
Places to Avoid
Avoid installing the printer in locations subject to:
❒ Direct drafts of hot or cold air
❒ Direct drafts from outside (Avoid locations near doors leading outside.)
❒ Sudden temperature or humidity changes
❒ Sources of high temperature, for example, near stoves or radiators
❒ Excessive dust
❒ Vibration
❒ Ammonia or other harmful fumes. (If you are planning to fumigate the room, or make liberal
use of insecticide, remove the printer first!)
❒ Excessive sunlight or humidity
❒ Lack of ventilation
❒ Low air pressure, e.g., located more than 2000 meters (6500 feet) above sea level
30 cm (11-13/16 inches)
40 cm (15-3/4 inches)
25 cm (9-7/8 inches)
60 cm (23-5/8 inches)
30 cm (11-13/16 inches)
[20 cm (7-7/8 inches) when the
face-up output tray* is not
installed.]
* Optional with the FS-1750