Introduction
vi
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
CDRH regulations
The Center of Devices and Radiological Health (CDRH) of the U.S. Food and Drug Admin-
istration implemented regulations for laser products on August 2, 1976. These regulations
apply to laser products manufactured after August 1, 1976. Compliance is mandatory for
products marketed in the United States. A label indicating compliance with the CDRH reg-
ulations must be attached to laser products marketed in the United States.
Ozone concentration
The printers generate ozone gas (O
3
) which may concentrate in the place of installation and
cause an unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we
recommend you not to install the printer in a confined area where ventilation is blocked.
(European/
Asian countries)
(U.S.A./Canada)
The labels shown are affixed to the
FS-3750. Similar labels are affixed
to same location on the FS-1750.
(Philippines)
To Next Page
Loading...
