Kyocera FS-1750 - SIMM to be Used; Installing and Removing Simms

5. Memory Expansion Installation
20
SIMM to be used
See your Kyocera dealer for purchasing information of the SIMMs that are best suited for
use with this printer.
Either 4 MB, 8 MB, 16 MB or 32 MB SIMMs can be used for memory expansion.
Installing and Removing SIMMs
Installing SIMMs
Insert the SIMM into the socket as shown right.
1.
Remove the SIMM from its package.
2.
Insert the connector end of the SIMM into
the socket.
3.
Carefully push the board upright until it
snaps into place. Make sure that the catches
at the ends of the socket fit into the holes at
the ends of the SIMM board.
Removing SIMMs
To remove a SIMM, carefully pull the end
catches slightly outwards and tilt the SIMM as
shown, then pull the SIMM out of the socket.
Reverse the procedure under Withdrawing the
Main Circuit Board from the Printer to put the
main circuit board back into the printer.
SIMM
Catch
Socket
Catch