2F8/2F9/2GA-1
1-6-4
11. Confirm that the printer's power switch is set
to off.
12. Insert the memory card into the printer's
memory card slot.
Figure 1-6-7
13. Turn printer power on.
14. When message display (1) is displayed to
detect firmware in the memory card.
15. Message display (2) is displayed during
downloading.
16. When message display (3) is displayed to
indicate downloading is finished.
17. Turn printer power off.
18. Remove the memory card from memory
card slot.
19. Turn printer power on.
20. Confirm that message display (4) is dis-
played after warm-up.
21. Print the status page. Print the status page
to check that the firmware version has been
updated.
Figure 1-6-8
Memory card slot
Memory card
(2)
(1)
(4)
Ready
Supervisor mode
CF-card reading
Supervisor mode
(3)
2GA_3000.001.021
05/10/26 [E1F9]
Memory
card
slot
Memory
card
Message display
Supplement (Normally: 00)
Classification (Normally: 0)
Product code
2F8: 30/31 ppm printer (EUR/USA model)
2F9: 35/37 ppm printer (EUR/USA model)
2GA: 45/47 ppm printer (EUR/USA model)
Release date: Year/Month/Day
Checksum
Update history
Build number
Firmware category
10: Engine controller
30: Main controller
Power switch: On
Power switch: On
Power switch: Off
NOTE:
Main controller firmware "2F9" should
be used since 35/37 ppm printer and
45/47 ppm printer are identical.
To Next Page
Loading...
