2F8/2F9/2GA-2
1-3-5
Service items Description
No. Items Description
Paper source position counter /Duplex/
Unit life counter /Drum unit/
Maintenance kit life counter -
Unit version /Paper feeder 1/
Unit EEPROM error bit0: Paper feeder 1
bit1: Reserved
bit2: Reserved
bit3: Duplex
bit4: Reserved
bit5: Bulk paper feeder
bit6: Reserved
bit7: Drum unit
Drum ID -
Serial interface information RS2: RS-232C
RS4: RS-422A
Drum sensitivity information -
Calibration table settings Setting value (FRPO I4), Hexadecimal
Optional paper feeder/stacker
information
1st 2 bytes
bit0: MP tray
bit1: Cassette 1
bit2: Paper feeder 1
bit3 to 6: Reserved
bit7: Duplex
bit8: Bulk paper feeder
bit9: Envelope feeder
bit10 to 15: Reserved
2nd 2 bytes
bit0: Face up
bit1: Face down
bit2: Reserved
bit3: Reserved
bit4 to 15: Reserved
Operation panel message lan-
guage
PMSG command setting (decimal)
Current temperature
0 to 50 °C/32 to 122 °F (in 1 °C/1.8 °F increment, “-” = Temperature/
humidity sensor is abnormal.)
Current humidity 25 to 90% RH (in 1% increment)
Absolute humidity
g/m
3
Number of rebooting for verti-
cal distortion check
-
Network interface card (IB-30)
version
-
MAC address -
Fixed asset number (maximum 16 characters)
Media type attributes Media type setting value from 1 to 28 (paper weight)
(unused media type are always 0x00.)
Memory SPD information (slot
1)
2 to 6 bytes, 8 to 36 bytes, 94 to 95 bytes (total 32 bytes)
Drum status information -
Drum sensitivity information -
To Next Page
Loading...
