2F8/2F9/2GA-1
1-5-16
4. Remove the screw form the fuser heater
lamp.
5. Remove the fuser heater lamp.
6. Check or replace the fuser heater lamp and
refit all the removed parts.
Seat the fuser heater lamp aligning its watt-
age mark and welding mark faced with the
correct direction and side.
Figure 1-5-21
30/31 ppm printer
(EUR/USA model)
35/37 and 45/47 ppm printer
(EUR/USA model)
Fuser heater lamp
Nut
Nut
Screw
Terminal
Terminal
Screw
Rating marking
Screw
Welding side
Fuser heater lamp
Fuser heater
lamp
To Next Page
Loading...
