Kyocera FS-2000D - Page 89

2F8/2F9/2GA-1
1-5-17
(3) Detaching and refitting the heat roller
Procedure
1. Remove the fuser heater lamp (See page
P.1-5-15).
2. Remove the heat roller (assembly) from the
fuser upper frame.
3. Remove the heat gear Z36, heat R bush
and heat L bush from the heat roller. (30/31
ppm printer [EUR/USA model])
Remove the heat gear Z46, two bearings
and two stoppers from the heat roller. (35/37
and 45/47 ppm printer [EUR/USA model])
4. Check or replace the heat roller and refit all
the removed parts.
Figure 1-5-22
Heat R bush
Heat L bush
30/31 ppm printer
(EUR/USA model)
35/37 and 45/47 ppm printer
(EUR/USA model)
Heat roller
Heat roller
Stopper
Stopper
Bush
Bush
Bearing
retainer
Bearing
Bearing
retainer
Bearing
Heat gear
Z46
Fuser upper
frame
Heat gear
Z36