2F8/2F9/2GA-1
1-5-19
(5) Detaching and refitting the fuser thermistor M, fuser thermistor S, and thermal cutout
Procedure
1. Remove the fuser unit (See page P.1-5-14).
2. Turn the fuser unit bottom side up.
3. Unlatch the six latches and then remove the
cord cover.
4. Unlatch the four latches and then remove
the fuser drawer connector.
5. Remove the one/two connector(s).
Figure 1-5-24
backside view
Fuser unit
Latch
Latch
Latch
Latch
Code cover
Fuser drawer
connector
*: 35/37 and 45/47 ppm printer [EUR/USA model] only.
Connector
Connector*
Latch
Latch
Latch
To Next Page
Loading...
