Kyocera FS-3040MFP - Page 388

11-26
Management
Applying Limit of Restriction
This specifies how the machine behaves when the counter has reached the limit of restriction. The table below
describes the action taken.
Use the procedure below to apply the restriction limit.
1 Press the System Menu/Counter key on the main unit
operation panel.
2 In the Sys. Menu/Count. menu, press the U or V key to
select [User/Job Account], and then press the OK key.
3 If user login administration is disabled, the user
authentication screen appears. Enter your login user
name and password and then press [Login]. For this, you
need to log in with administrator privileges. Refer to
Adding a User on page 11-6 for the default login user
name and password.
NOTE: Refer to Character Entry Method on Appendix-5 for
details on entering characters.
4 In the User/Job Account menu, press the U or V key to
select [Job Account. Set.].
5 Press the OK key. The Job Account. Set. menu appears.
Item Description
Immediately *
* The next job will be prohibited in sending or in storing in the box.
Job stops when the counter reaches its limit.
Subsequently Printing/scanning of the job continues but the
subsequent job will be rejected.
Alert Only Job continues while displaying an alert message.
Sys. Menu/Count.: a b
*********************
2 User Property
3 Common Settings
[ Exit ]
1 User/Job Account
Login User Name L b
*******************
Login Password:
[ Login ]
User/Job Account: a b
1 User Login Set.
*********************
3 Unknown ID Job
[ Exit ]
2 Job Account.Set.
Job Account.Set.: a b
4 Each Job Account
5 Account. List
*********************
[ Exit ]
6 Default Setting
Downloaded From ManualsPrinter.com Manuals