What to do if my Kyocera All in One Printer prints a status page but not jobs from the computer?
First, ensure both ends of the printer cable are securely connected. If the issue persists, try replacing the printer cable. Also, try printing another file or using a different print command. If the problem is specific to one file or application, review the printer driver settings for that application.
How to fix Kyocera Printer when nothing lights up?
If nothing lights up on the operation panel of your Kyocera printer, and the fan makes no noise, start by checking that the power cord is properly plugged into the power outlet. If it is, securely plug it in and try turning the printer on again. If the problem persists, unplug the power cord, wait for more than a minute, then plug it back in and try again. Also, ensure that the power switch is pressed.
Why is my Kyocera All in One Printer printing faint or blurred?
Check if the EcoPrint setting is turned on; if so, switch it off on the operation panel. Also, verify that the paper type setting matches the paper you are using. If needed, refresh the drum to restore printing quality and adjust the print density. If you're using damp paper, replace it with a newer, dryer paper. If the problem persists, call for service.
What to do if my Kyocera FS-2100DN shows 'Drum unit is not installed'?
The drum unit is either not installed or incorrectly inserted. Insert the drum unit securely. If the problem persists, contact your Service Representative.
What to do if my Kyocera FS-2100DN All in One Printer shows 'Check cassette #'?
This message appears when a paper lift error occurs in the cassette. Pull out the indicated cassette (either the paper cassettes or optional paper feeders) and ensure the paper is loaded correctly. Note that if this error occurs repeatedly, the message 'Call service' will be displayed.
Why does my Kyocera FS-2100DN say 'Cannot duplex print on this paper'?
You tried to print with a paper size and type that is not suitable for duplex printing. Press [OK] to print on one side of the paper only.
How to remove dirt from paper edges on Kyocera Printer?
To remove dirt from the top edge or back of the paper on your Kyocera printer outputs, try printing several pages to see if the issue resolves itself. If the problem continues, clean the registration roller. If the problem persists after cleaning, call for service.
What to do if Kyocera Printer displays 'Incorrect account ID'?
If your Kyocera printer displays 'Incorrect account ID', it indicates that the entered Account ID does not match the registered ID. Ensure you are using the correct Account ID.
What to do if my Kyocera All in One Printer shows 'Developer unit is not installed'?
The developer unit is either not installed or incorrectly inserted. Insert the developer unit securely. If the problem persists, contact your Service Representative.
What does 'Check waste toner box' mean on Kyocera Printer?
The 'Check waste toner box' message on your Kyocera printer indicates one of two things: either a new waste toner box needs to be installed, or the current waste toner box is full.
Details how to load paper into the printer's cassettes and multi-purpose tray.
Configures network settings, including IP address and protocol details.
Guides on replacing the toner container and necessary steps.
Lists and explains various error messages and their corrective actions.
Provides step-by-step guidance for clearing paper jams.
General| Category | All in One Printer |
|---|---|
| Technology | Laser |
| Maximum Resolution | 1200 x 1200 DPI |
| Duplex Printing | Yes |
| Print Margins | 4 mm |
| Standard Printer Languages | PCL6 |
| Maximum Print Size | A4 |
| Interface | USB 2.0, Ethernet |
| Warm-up Time | 15 s |
To Next Page