Appendix
A-18
Special Paper
The following types of special paper can be used:
Use paper that is sold specifically for use with copiers or printers (heat-fusing type). When using transparencies, labels, thin
paper, postcards, or thick paper, feed the paper from the MP tray. For details, refer to MP Tray Set. (MP tray settings) on
page 4-26.
Since the composition and quality of special paper vary considerably, special paper is more likely than white bond paper to
give trouble during printing. No liability will be assumed if moisture and so forth given off during printing on special paper
causes harm to the machine or operator.
Transparency
Transparencies must be able to withstand the heat of fusing during the printing process. The recommended transparency
product is 3M CG3700 (Letter, A4).
The table below lists the specifications for transparency:
Paper Type to be Used Paper Type to be Selected
Overhead projector transparencies Transparency
Rough paper Rough
Thin paper (60 to 64 g/m²) Vellum
Label Labels
Recycled paper Recycled
Preprinted paper Preprinted
Bond paper Bond
Postcards Cardstock
Colored paper Color
Prepunched paper Prepunched
Letterhead Letterhead
Envelopes Envelope
Thick paper (120 to 220 g/m²) Thick
High-quality paper High Quality
Custom Custom 1~8
Note Before purchasing any type of special paper, test a sample on the machine and check that printing quality is
satisfactory.
Item Specification
Tolerance of heat Must tolerate at least 190 °C (374 °F)
Thickness 0.100 to 0.110 mm (3.9 to 4.3 mils)
Material Polyester
Dimensional accuracy ±0.7 mm (±0.0276 inches)
Squareness of corners 90° ±0.2°
To Next Page
Loading...
Need help?
General
