What to do if Kyocera Printer shows 'Drum unit is not installed'?
If your Kyocera printer shows the message 'Drum unit is not installed,' the drum unit is either missing or not correctly inserted. Make sure the drum unit is securely inserted. If the issue continues, contact your Service Representative.
What to do if my Kyocera All in One Printer prints a status page but not jobs from the computer?
First, ensure both ends of the printer cable are securely connected. If the issue persists, try replacing the printer cable. Also, try printing another file or using a different print command. If the problem is specific to one file or application, review the printer driver settings for that application.
What does 'Check waste toner box' mean on Kyocera Printer?
The 'Check waste toner box' message on your Kyocera printer indicates one of two things: either a new waste toner box needs to be installed, or the current waste toner box is full.
What to do if my Kyocera All in One Printer shows 'Top tray is full of paper. Remove the paper.'?
You must remove all printed pages from the top tray. The printer will resume printing to the top tray once it detects that the tray is empty.
What to do if my Kyocera All in One Printer shows 'Check waste toner box'?
This message indicates that the waste toner box is either not installed or full. Install a new waste toner box if needed.
Why does my Kyocera FS-2100DN say 'Cannot duplex print on this paper'?
You tried to print with a paper size and type that is not suitable for duplex printing. Press [OK] to print on one side of the paper only.
How to resolve dropouts or stray dots on printouts from Kyocera FS-2100DN at high altitude?
Change the Altitude Adj. setting in the Service Setting menu to High 1. If there is still no improvement, change the setting to High 2.
How to solve 'Printing incomplete or out of position' on Kyocera FS-2100DN All in One Printer?
Check that the application software is correctly operated.
How to fix gray background on my Kyocera All in One Printer?
Refresh the drum to restore the printing quality, and then adjust the print density. If the problem persists, call for service.
Why is my Kyocera All in One Printer printing faint or blurred?
Check if the EcoPrint setting is turned on; if so, switch it off on the operation panel. Also, verify that the paper type setting matches the paper you are using. If needed, refresh the drum to restore printing quality and adjust the print density. If you're using damp paper, replace it with a newer, dryer paper. If the problem persists, call for service.
General| Category | All in One Printer |
|---|---|
| Technology | Laser |
| Maximum Resolution | 1200 x 1200 DPI |
| Duplex Printing | Yes |
| Print Margins | 4 mm |
| Standard Printer Languages | PCL6 |
| Maximum Print Size | A4 |
| Interface | USB 2.0, Ethernet |
| Warm-up Time | 15 s |
Details how to load paper into the printer's cassettes and multi-purpose tray.
Configures network settings, including IP address and protocol details.
Guides on replacing the toner container and necessary steps.
Lists and explains various error messages and their corrective actions.
Provides step-by-step guidance for clearing paper jams.
To Next Page