Why is my Kyocera All in One Printer printing faint or blurred?
Check if the EcoPrint setting is turned on; if so, switch it off on the operation panel. Also, verify that the paper type setting matches the paper you are using. If needed, refresh the drum to restore printing quality and adjust the print density. If you're using damp paper, replace it with a newer, dryer paper. If the problem persists, call for service.
How to fix gray background on my Kyocera All in One Printer?
Refresh the drum to restore the printing quality, and then adjust the print density. If the problem persists, call for service.
How to solve 'Printing incomplete or out of position' on Kyocera FS-2100DN All in One Printer?
Check that the application software is correctly operated.
How to resolve dropouts or stray dots on printouts from Kyocera FS-2100DN at high altitude?
Change the Altitude Adj. setting in the Service Setting menu to High 1. If there is still no improvement, change the setting to High 2.
How to fix dirt on the top edge or back of the paper from Kyocera All in One Printer?
If the problem persists after printing several pages, clean the registration roller. If the problem is still not solved after cleaning, call for service.
Why is my Kyocera Printer printing faint or blurred?
If your Kyocera printer is producing faint or blurred prints, first check the EcoPrint settings on the operation panel and ensure it is switched off. Also, verify that the paper type setting matches the paper you are using. If the issue continues, replacing the paper with a newer, dryer paper may help.
What to do if Kyocera Printer shows 'Check cassette #'?
If your Kyocera printer displays the message 'Check cassette #,' it indicates a paper lift error in the specified paper source's cassette. To resolve this, pull out the indicated cassette (either the paper cassettes or optional paper feeders) and ensure the paper is loaded correctly.
What to do if Kyocera Printer prints status page but not computer jobs?
First, ensure both ends of the printer cable are securely connected. If the issue persists, try replacing the printer cable or the interface cable. Also, test printing with another file or print command. If the problem is specific to a file or application, examine the printer driver settings for that application.
What to do if Kyocera Printer says 'Developer unit is not installed'?
If your Kyocera printer displays the message 'Developer unit is not installed,' it means the developer unit is either not installed or incorrectly inserted. Ensure the developer unit is securely inserted. If the problem persists, contact your Service Representative.
What to do if Kyocera Printer shows 'Drum unit is not installed'?
If your Kyocera printer shows the message 'Drum unit is not installed,' the drum unit is either missing or not correctly inserted. Make sure the drum unit is securely inserted. If the issue continues, contact your Service Representative.
General| Category | All in One Printer |
|---|---|
| Technology | Laser |
| Maximum Resolution | 1200 x 1200 DPI |
| Duplex Printing | Yes |
| Print Margins | 4 mm |
| Standard Printer Languages | PCL6 |
| Maximum Print Size | A4 |
| Interface | USB 2.0, Ethernet |
| Warm-up Time | 15 s |
Details how to load paper into the printer's cassettes and multi-purpose tray.
Configures network settings, including IP address and protocol details.
Guides on replacing the toner container and necessary steps.
Lists and explains various error messages and their corrective actions.
Provides step-by-step guidance for clearing paper jams.
To Next Page