To Next Page

To Previous Page

(22) The registration clutch does not operate. ....................................................................................... 1-5-45

(23) The feedshift solenoid does not operate......................................................................................... 1-5-45

(24) The toner feed solenoid does not operate. ..................................................................................... 1-5-45

(25) The cleaning lamp does not turn on. .............................................................................................. 1-5-46

(26) The fuser heater does not turn on (C6000). ................................................................................... 1-5-46

(27) The fuser heater does not turn off. ................................................................................................. 1-5-46

(28) Main charging is not performed. ..................................................................................................... 1-5-46

(29) Transfer charging is not performed. ................................................................................................ 1-5-46

(30) No developing bias is output. ......................................................................................................... 1-5-46

(31) The message requesting paper to be loaded is shown when paper is present in

the upper cassette........................................................................................................................... 1-5-46

(32) The message requesting paper to be loaded is shown when paper is present in

the lower cassette. .......................................................................................................................... 1-5-47

(33) The message requesting paper to be loaded is shown when paper is present on the MP tray...... 1-5-47

(34) The size of paper in the upper cassette is not displayed correctly. ................................................ 1-5-47

(35) The size of paper in the lower cassette is not displayed correctly. ................................................. 1-5-47

(36) The printing width of the paper on the MP tray is not detected correctly. ....................................... 1-5-47

(37) A paper jam in the paper feed, paper conveying or fuser section is indicated

when the power switch is turned on. ............................................................................................... 1-5-48

(38) The message requesting covers to be closed is displayed when the front cover and

conveying cover are closed............................................................................................................. 1-5-48

(39) Others. ............................................................................................................................................ 1-5-48

1-5-5 Mechanical problems ............................................................................................................................. 1-5-49

(1) No primary paper feed. ................................................................................................................... 1-5-49

(2) No secondary paper feed................................................................................................................ 1-5-49

(3) Skewed paper feed. ........................................................................................................................ 1-5-49

(4) Multiple sheets of paper are fed at one time. .................................................................................. 1-5-49

(5) Paper jams. ..................................................................................................................................... 1-5-49

(6) Toner drops on the paper conveying path....................................................................................... 1-5-49

(7) Abnormal noise is heard. ................................................................................................................ 1-5-50

1-5-6 Repetitive defects gauge ........................................................................................................................ 1-5-51

(1) Repetitive defects gauge................................................................................................................. 1-5-51

fineline6