Caution
NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION.
Notice on Software
SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER’S EMULATION MODE. The printer is
factory-set to emulate the HP PCL 6. The emulation mode can be changed by following the procedures described in
the User’s Manual contained as an electronic file in the Kyocera Mita Digital Library CD-ROM supplied with the printer.
Notice
The information in this guide is subject to change without notification. Additional pages may be inserted in future edi-
tions. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition.
No responsibility is assumed if accidents occur while the user is following the instructions in this guide. No responsi-
bility is assumed for defects in the printer’s firmware (contents of its read-only memory).
This guide, any copyrightable subject matter sold or provided with or in connection with the sale of the page printer,
are protected by copyright. All rights are reserved. Copying or other reproduction of all or part of this guide, any copy-
rightable subject matter without the prior written consent of Kyocera Corporation is prohibited. Any copies made of all
or part of this guide, any copyrightable subject must contain the same copyright notice as the material from which the
copying is done.
Table of Contents
! "
# $
% &'(')*+,
$ #-#.
, -
©2001 by Kyocera Corporation All rights reserved
Revision 1.1 August 2001
To Next Page
Loading...
Need help?
General
