(22) The registration clutch does not operate. ....................................................................................... 1-5-45
(23) The feedshift solenoid does not operate......................................................................................... 1-5-45
(24) The toner feed solenoid does not operate. ..................................................................................... 1-5-45
(25) The cleaning lamp does not turn on. .............................................................................................. 1-5-46
(26) The fuser heater does not turn on (C6000). ................................................................................... 1-5-46
(27) The fuser heater does not turn off. ................................................................................................. 1-5-46
(28) Main charging is not performed. ..................................................................................................... 1-5-46
(29) Transfer charging is not performed. ................................................................................................ 1-5-46
(30) No developing bias is output. ......................................................................................................... 1-5-46
(31) The message requesting paper to be loaded is shown when paper is present in
the upper cassette........................................................................................................................... 1-5-46
(32) The message requesting paper to be loaded is shown when paper is present in
the lower cassette. .......................................................................................................................... 1-5-47
(33) The message requesting paper to be loaded is shown when paper is present on the MP tray...... 1-5-47
(34) The size of paper in the upper cassette is not displayed correctly. ................................................ 1-5-47
(35) The size of paper in the lower cassette is not displayed correctly. ................................................. 1-5-47
(36) The printing width of the paper on the MP tray is not detected correctly. ....................................... 1-5-47
(37) A paper jam in the paper feed, paper conveying or fuser section is indicated
when the power switch is turned on. ............................................................................................... 1-5-48
(38) The message requesting covers to be closed is displayed when the front cover and
conveying cover are closed............................................................................................................. 1-5-48
(39) Others. ............................................................................................................................................ 1-5-48
1-5-5 Mechanical problems ............................................................................................................................. 1-5-49
(1) No primary paper feed. ................................................................................................................... 1-5-49
(2) No secondary paper feed................................................................................................................ 1-5-49
(3) Skewed paper feed. ........................................................................................................................ 1-5-49
(4) Multiple sheets of paper are fed at one time. .................................................................................. 1-5-49
(5) Paper jams. ..................................................................................................................................... 1-5-49
(6) Toner drops on the paper conveying path....................................................................................... 1-5-49
(7) Abnormal noise is heard. ................................................................................................................ 1-5-50
1-5-6 Repetitive defects gauge ........................................................................................................................ 1-5-51
(1) Repetitive defects gauge................................................................................................................. 1-5-51
To Next Page
Loading...
