Top Page > Getting Started > Entering Characters > Value Input Mode
Value Input Mode
Value input mode becomes active when configuring settings such as paper size or copy zoom ratio. In this
mode, use the keys as follows:
● To enter a digit
Press a number key. Press the number keys successively to enter a multi-digit number.
● To increase or decrease the current value in units
Press the [
][ ] keys. The unit of increments depends on the setting you are configuring.
● If a digit is entered more than three seconds after the last input, the entered digit replaces the current value.
● When the maximum number of digits has already been entered, the next input digit replaces the current value.
● If the current value is too large or too small for the current setting, it will not be accepted. In this case, pressing the [ ] or [
] key changes the value to the minimum or maximum value for the current setting, respectively.
Top Previous Next
Copyright © 2009
Contents Previous Next Settings
To Next Page
Loading...
