Top Page > Using the Scanner Function > Scanning Using the Control Panel > Basic Operation for Sending Scanned Files > Specifying
the scan destination
Specifying the scan destination
This section describes how to specify a destination using the following keys:
● One Touch buttons
Use these to specify destinations registered as Quick Dial entries.
● [Pause/Redial] key
Press this to specify the last used destination as the destination for the current job.
Using the One Touch buttons
Press the One Touch button to which the desired Quick Dial entry is registered.
Press the [Shift] key to toggle the One Touch buttons between Quick Dial entries Nos.1 to 10 and
Nos. 11 to 20.
Using the [Pause/Redial] key
Press the [Pause/Redial] key to select the last used destination.
● When you specify a scan destination, the machine's scan settings change automatically according to the information
registered for that destination in the Address Book. If necessary, you can change the scan settings using the control panel.
● The [Pause/Redial] key is not effective for the first scan job after the machine is turned on.
● To select destinations not registered as Quick Dial entries, use the [Address book] key.
● For details about how to specify destinations using the [Address book] key, see Basic Operation for Sending Scanned Files .
Contents Previous Next Settings
To Next Page
Loading...
