Top Page > Using the Fax Function > Sending a Fax > Basic Operation for Sending a Fax
Basic Operation for Sending a Fax
This section describes the basic operation for sending a fax.
● The original in the ADF takes precedence over the original on the exposure glass if you place originals both in the ADF and on
the exposure glass.
Press the [Facsimile] key.
Place the original on the exposure glass or in the ADF.
If necessary, configure the advanced scan settings.
Enter the fax number (up to 40 characters) using the number keys.
Press the [B&W Start] key.
When using the exposure glass in Memory Transmission mode, you will be prompted to place another
original. In this case, proceed to the next step.
If you have more originals to scan, press [1] within 60 seconds, place the next original
on the exposure glass, and then press the [OK] key. Repeat this step until all originals are
scanned.
If you do not press [1] within 60 seconds, the machine will start to dial the destination.
When all originals have been scanned, press [2] to start sending the fax.
● A fax number can contain 0 to 9, pause, " ", " ", and space.
● If necessary, insert a pause in a fax number. The machine pauses briefly before it dials the digits following the pause. You
Contents Previous Next Settings
To Next Page
Loading...
