Top Page > Maintenance > Cleaning > Cleaning the Friction Pad and Paper Feed Roller
Cleaning the Friction Pad and Paper Feed Roller
If the friction pad or paper feed roller is dirty, a multi-feed or jam might occur. In this case, clean the
friction pad and paper feed roller as follows:
● Unplug the power cord from the wall outlet before you move the machine. While moving the machine, you
should take care that the power cord will not be damaged under the machine.
● Do not use chemical cleaning fluids or organic solvents such as thinner or benzine.
Turn off the power.
Unplug the power cord from the wall outlet. Remove all the cables from the machine.
Lift tray 1 and pull it slightly toward you. Then, using both hands, pull the tray fully out.
Place the tray on a flat surface. If there is paper in the tray, remove it.
Wipe the friction pad with a damp cloth.
Wipe the rubber part of the roller with a soft damp cloth. After that, wipe it with a dry
cloth to remove the moisture.
Contents Previous Next Settings
To Next Page
Loading...
