Setup and Registration
6-37
6
Setting Reception Restriction
You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No.
and Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject
List] for Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from
senders whose Local FAX Number is not registered are rejected. To change the reception restriction, follow the
steps below.
1 Refer to Basic Operation Procedure on page 6-7.
2 Press the U or V key to select [RX Restriction].
3 Press the OK key.
4 Press the U or V key to select reception
restriction. To not use the reception restriction,
select [Off]. To restrict the other parties only to the
ones registered in Permit FAX No. and Permit ID
No. as well as the ones registered in the Address
Book, select [Permit+Addr Book]. To block
incoming faxes from senders registered in Reject
FAX No., select [Reject List].
5 Press the OK key.
Unknown Number Reception
Select whether to receive the fax of that the number is unknown when [Reject List] is set for Reception
Restriction. To change the reception restriction for the unknown fax number, follow the steps below.
1 Refer to Basic Operation Procedure on page 6-7.
2 Press the U or V key to select [UnknownNumber
RX].
3 Press the OK key.
TX/RX Restrict.:
a
b
1
TX Restriction
*********************
3
Permit No. List
[ Exit ]
2
RX Restriction
TX/RX Restrict.:
a
b
4
Permit ID List
5
Reject No. List
*********************
[ Exit ]
6
UnknownNumber RX
To Next Page
Loading...
Need help?
General
