38
Mode2: Print an image to the paper which is same or large enough.
The Paper Priority in Selection:
1. image size = paper size
2. image size < paper size
Mode3: Print an image, if any paper exists.
The Paper Priority in Selection:
1. image size = paper size
2. image size < paper size
3. image size > paper size
Tolerance:
Even if output file size is larger than regular paper size, it is possible
to output on its regular size, up to the value of tolerance. When
paper size is selected, even if output file size is little bit larger than
regular paper size, it is possible to output on the paper or regular
size by changing the value of tolerance due to the allowance value
is expanded”
Screening:
Change print pattern of gray area. Adjust the gray area, which is
described in grid, by changing the number of lines and the angle. It
is possible to change the pattern of gray by changing the number of
lines per inch (lpi) and the angle of line”
Resolution Conversion:
The image can be printed with high quality if you check this item
when the resolution is not 600dpi (any resolution except for 600dpi).
However it takes longer time than usual until printing is finished.
Number of prints:
Setting of number of print
1 – 999
Rotation:
Select output direction
Auto
0
90
180
270
To Next Page
Loading...
