39
Tray Selection:
Select paper deck
Auto
Deck 1
Deck 2
Bypass
Cut Mode:
Select cut mode of paper
Check Standard Cut
No check Synchronized Cut
Mirror:
Setting of mirror
Density:
Set Image Density
When input value is smaller, it shows lighter image, and vice versa.
1 - 13
Image Shift:
Set if Image is required to shift from the center.
When “Set” button is clicked, the following dialog is popped up.
Image placement is selectable up-shown 9 location.
When fine adjustment of the location is necessary, put the value to
move to Offset X and Y.
To Next Page
Loading...
