Kyocera KM-C830D - Network (TCP;IP) Settings

5
2. Set-up
Use the M and N cursor keys to select “Interface” and then
press the Enter key.
Use the M and N cursor keys to select “Option 1” and then
press the Enter key.
Use the M and N cursor keys to select “TCP/IP” and then
press the Enter key.
2-3 Network (TCP/IP) settings
When this machine is to be used as a network printer, it is necessary
to set the corresponding IP address for the printer.
Notes
• The IP address that should be registered here will differ depending
upon your network environment. Check with your network
administrator BEFORE performing this setting.
• If you are using a DHCP server to automatically configure the IP
address, this setting will not be necessary because DHCP server
configuration is already enabled as the factory default setting.
Press the Printer key. The machine will switch to the printer
mode.
Use the M and N cursor keys to select “MENU” and then
press the Enter key.
1
2
3
4
5
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification
Inch specification
Metric specification